Untitled Document

**FIG <2>**
`DATA ACQUISITION USER INTERFACE 1.0` `Max spool motor speed (rpm) : 600` `Rate of increase of SM speed : 10` `Transverse motor speed ratio factor : 25` `Material ID : XXXXXXXX` `Tensile strength (psi) : 20` `Spool diameter (inches) : 0.5` `Original wire diameter (inches) : 0.0065` `Lubricant ID : XXXXXXXX` `Lubricant temperature (Fahrenheit) : 100` `% reduction in area : 7` `Semi die angle (degrees) : 4` `Remarks : Fake` `Sampling Rate (samples/sec) : 100` `Requested number of samples : 500` `Output file name : sample1.dat` `Use voltage divider for speed (y/n) : y` `Tensiometer (1=10kg 2=5kg 3=2kg) : 3` `ACCEPT CLEAR EXIT` `<Enter>:accept/forward F1:forward F2:back <ESC>:exit ?:help`

                                                                                
                      DATA ACQUISITION USER INTERFACE 1.0


      Max spool motor speed (rpm)                  : 600
      Rate of increase of SM speed                 : 10
      Transverse motor speed ratio factor          : 25
      Material ID                                  : XXXXXXXX
      Tensile strength (psi)                       : 20
      Spool diameter (inches)                      : 0.5
      Original wire diameter (inches)              : 0.0065
      Lubricant ID                                 : XXXXXXXX
      Lubricant temperature (Fahrenheit)           : 100
      % reduction in area                          : 7
      Semi die angle (degrees)                     : 4
      Remarks                                      : Fake
      Sampling Rate (samples/sec)                  : 100
      Requested number of samples                  : 500
      Output file name                             : sample1.dat
      Use voltage divider for speed (y/n)          : y
      Tensiometer (1=10kg 2=5kg 3=2kg)             : 3


               ACCEPT            CLEAR               EXIT


       <Enter>:accept/forward  F1:forward  F2:back   <ESC>:exit  ?:help